Reach Electric Forklift Safety Precautions

                                 Reach Electric Forklift Safety Precautions

Reach battery forklift is different from an electric forklift trucks and warehouse equipment efficient car type electric counterbalanced forklift trucks, due to its high operational efficiency, but also the requirements of the channel is relatively small, generally 2.8 m can be achieved cornering turn , it is widely used in factory floor and warehouse logistics required parameters. Reach electric forklift China market to maintain a very high amount, so today was introduced to give you: Reach Electric Forklift Safety Precautions

Reach electric china forklift Pictures

1, do not depress the accelerator pedal before turning the key switch thinking, otherwise there will be trouble codes and forklift truck will not run

2, running in the truck reversing lever to pull in the opposite direction, the electric brake work, the truck will decelerate to a stop and slowly will run in the other direction.

3, such as electric forklift steering hydraulic steering system, when the pump motor stops working, the steering will be very difficult, you must start the pump motor can be easily turned.

4, prohibiting the same time depress the brake pedal and the accelerator pedal.

5, prohibits the use of excessive discharge and charge it in time, for a long time should be set aside additional power once a week.

6, unscheduled inspections of electric forklift battery level, should be lower than the calibration line if replenish distilled water, do not add water, river water, mineral water, avoid entering miscellaneous antagonists cause internal battery self-discharge fault, nor add electrolyte pressure, otherwise they will increasing the concentration of the electrolyte and shorten battery life

7, reach trucks use in particular should pay attention to in a timely manner for proper battery charging and battery maintenance. Note that when the battery charging methods, both to make the battery is fully charged, the battery can not cause excessive charging.

8, reach trucks in operation, minimize the use of long-range acceleration time, when the vehicle is started, the speed increase after stabilize the accelerator pedal, such as better roads, the vehicle will continue to accelerate. Decelerate the vehicle need to relax the accelerator pedal, gently depress the brake pedal, which can take full advantage of the deceleration of energy, if the vehicle has a regenerative braking function, you can make the kinetic energy is recovered during deceleration. When the vehicle ramp down, do not disconnect the drive motor circuit, gently depress the brake pedal, the vehicle runs on regenerative braking, the vehicle down the kinetic energy use and reduce the battery energy consumption.

9, the vehicle is running, do not "forward, backward" direction switch mistaken turn switch. Unless urgent need to slow down, do not directly to the brake pedal in the end. Vehicles using the process, found the battery is low (by electricity meter, power loss alarm indicator and other devices to get), you should charge the battery as soon as possible, to prevent excessive battery discharge.

10, electric forklift operation process forward as much as possible is to pay attention to safety, do not overload; and usually do maintenance work, not with the trouble-free operation, in order to avoid unnecessary accidents, keep in mind safety first.