A driving 1.5 tons rough terrain forklifts must go through professional training, through the assessment of production safety supervision department, obtain special operating permit, and after the company agreed to before being driving, operating without a license is prohibited. Do not drink and drive, driving not diet. Chats. Cell phones and talk walkie-talkie.
Second, the driver should be compliance law, standardized operation, safe driving, raise "safety first, prevention first" ideology.
Third, while driving the truck ban in high-altitude operations personnel with fork lift, in order to avoid falling from height accidents; prohibiting the use of a single fork operation, fork load carrying capacity should be consistent with the provisions prohibit overloading operations.
Fourth, the truck ban speed fork to take the job of goods, prohibited personnel standing on the forks; prohibit officers standing around when the fork fork to take cargo operations, in order to avoid collapse of the goods wounding.
Five, the driver of the vehicle should be checked before the job of lifting chain, door frame, fork without injury, bolts are secure; check whether you need refueling, lubricants, check the startup, operation, and braking performance; and checking lighting, sound signal is complete and valid, and then start to confirm normal operation; after starting the engine, listen to police engine running, check order status of each instrument. When there is a mechanical problem, can not repair themselves. Turn off the truck and inform machinery repair personnel.
Sixth, the driver started the truck should look around before, after confirming that no obstacles impede traffic safety start; start when loading a smooth start slowly and make sure smooth and reliable cargo.
Seven, the driver at the time of the fork goods, demand inspection fork spacing, so that the two forks load balancing, load forks should be as deep below, note the fork tip does not touch other goods; With a minimum of mast tilt to stabilize cargo, to avoid sliding backwards. The bottom of the fork height from the ground should be kept at a distance of 300-400mm travel.
When eight, truck driver loading highly obscured sight, should fall open truck; reversing signal to be issued when reversing, you must always pay attention to swing the car when the steering wheel control, speed to be smooth to drive back and forth to observe whether and pedestrians.
Nine, driving high mast diesel forklift or travel in and out of the way to the job site shall not rise too high forks, pay attention to whether the obstruction of the sky, with the brakes prohibit loading and high-speed cornering.
Ten, the main road truck driver traveling in the factory when not exceed 30km / h, other roads shall not exceed 20km / h. To maintain a certain distance from the vehicle in front when driving, if a pedestrian or vehicle should send a signal when the forward, when the flame is prohibited downhill slide.
XI during unloading truck driving speed should be slow and steady, do not pay attention to the wheels rolling mat surgery and other items other items, in order to avoid collapse wounding; after discharge should drop the fork to the normal driving position before driving.
没有评论:
发表评论