Inspection and maintenance of forklift

Forklift driving before examination

(1) the project in accordance with the provisions, each part of the technical condition of vehicle inspection standard, make the difference between the ten intact.

(2) check the vehicle driving license, driving license and other documents must be running before driving, prohibited the missing card, little card, driving without a license.

Driving

(3) the all terrain forklifts‍ drivers must strictly abide by the "code of conduct internal traffic safety management standards" and "production safety when driving".

(4) should be observed around the situation started before the forklift, (pressure or braking vehicle, brake pressure gauge readings must reach the specified value can be started) to confirm the safety of the whistle to start.

(5) the forklift driving fork bottom height should maintain 300 ~ 400 mm, the door frame must be backward.

(6) forklift at run time, get off to allow any one fork leg, forbidden to stand.

(7) the factory car driving shall not fork lift too high. Import and work site or driving on the way over, should pay attention to whether there is an obstacle scraping

Hit. Forbidden brakes and swerved.

(8) the forklift work, landing must be stable, should use the rope, rope chain firmly closed if necessary. Numerical fork must strictly according to the vehicle load curve specified goods, overloading is strictly prohibited.

(9) the factory fork vehicle travel at more than 7 degrees and is higher than for a speed on the downhill, non special circumstances shall not use the foot brake.

(10) the forklift after parking prohibited goods will be hanging in the air, after the discharge should drop the lifting frame after running.

(11) the forklift fork loading of goods, cargo weight should be the average share in two forks, the goods shall not be skewed, goods should be against the side baffle shelf. Small goods should be put in a set of bins (plate), to prevent from falling. The car contained articles shall not be block the driver's line of sight.

(12) in the process of loading and unloading of goods, must use the brake fork lift truck. If the crane loading and unloading workpieces, the driver must get out of the cab.

(13) the fork in the near or withdrawal of goods, the speed should be slow and steady rolling wheel, pay attention not goods, Dianmu (pallet) and a fork head don't scrape and touch objects support personnel.

(14) in the area of the factory and construction site, no more than ten kilometers per hour, and out of the factory gate, workshop, warehouse and the construction site, no more than 3 kilometers per hour. Forklift driving observed, prevent scratch, wounding.

(15) the car plant in the fork lifting, the lifting frame shall be with the ground forward, not to the lifting frame forward.

(16) the 2.5 tons Diesel forklift trucks‍ lifting or runs, to prohibit any person standing on the fork to control the object or the balance effect. Forklift lifting objects, goods are prohibited in nearby people.

(17) prohibit the use of the fork and other attachments lifting personnel engaged in the work high above the ground and the prohibition of single fork operation or use the fork to the top, pull, prohibit the use of inertia brake is rolling round or easy to roll goods, prohibited methods turn pallet pick use the fork to discharge. The prohibition of high-speed forks goods.

(18) are not allowed in the dock on the shore directly fork shipment goods and not in the train edge direct fork items.

(19) the forklift truck stop the engine idling, should make the mast tilted back. When the engine flameout, should the hoisting sliding frame falls, the fork is placed horizontally on the ground.

(20 factory in the factory, workshop and the construction site of the parking of vehicles, drivers are not allowed to leave the car, such as the need to temporarily leave, must take the key off, the switch pull.

Forklift cars maintenance

(1) maintenance of vehicles, should be the gear lever in neutral, take braking, wheel and supporting mask burdened the sliding frame and protective measures.

(2) clean forklift and crane carriage; fastening screw; check the supplementary fuel, lubricating oil etc..

In addition to the above battery forklift shall comply with the relevant safety regulations for technical operations, and shall also comply with relevant safety regulations for technical operations of battery car.‍